Skip to main content

The Coinapult. The Coin Flipping Catapult!



I build a coin flipper catapult, so my daughter wouldn't keep destroying our game boards. She's not great at flipping the coin, so I thought I'd make her something to help out!  As of this point, I think I like flipping coins more than her! 



I made this from resawn claro walnut and 3/8 birch dowels. It flips your coin in the the air and you can either catch it, or let it land. Regardless you'll get a unbiased launch every time you use it!

The walnut is sourced from a place that sells cut off material in 50lb bags for $9. So there is always some walnut in my shop for these small projects. I just love the look of the grain in this piece.

I used boiled linseed oil to pop the grain on the walnut, and really give this fun piece that finished look!

The design is super simple. I'm not one for over complicating an item. Just two sides and two dowel make up the base. The flipper is just held in place by the tension on the rubber band.

I intend to use it pretty heavily! It does flip it pretty high, I might have to dial that back a bit!! That is just a matter of a larger band. 

Comments

Popular posts from this blog

Book Tablet Holder

Tablet stand made from a 400 page book and some epoxy resin. Paper micarta is the proper term for it, but it doesn't really capture the essence of the idea. Those 400 pages hold but a single story, and now they can upright a device capable of holding thousands of stories. And with only a book and 30 some odd ounces of epoxy, you can make your own! Just don't use a book that is one of your favorites. Which  honestly is why I picked this one, and the fact that the name was well suited! Really it's the ultimate upcycling!

Rikon Mini Lathe

I got busy this weekend and completed a couple of projects. I took a number of pictures of my new lathe in action. Most of them during the turning of a recent euro stlye pen made from padauk and ebony with a CA finish. It was a SF Giants theme, and the lathe was covered with padauk streamers and ebony dust. Very cool first project. I had a little trouble with the finish owning to the extreme cold in the garage, but overall a pretty good result. As I normally do, I forgot something. I forgot to bring in the camera and upload the pictures to photobucket so I could post them. As such, there is once again no proof. sigh... Everything is simpler. No more wrench to move the tool rest or tail stock. No more indexing pin to take off the faceplate. No more hassle removing the centers or mandrels. Man what a difference! In addition I tried turning a few things between centers. Basically just mangled some spindle blanks. Good fun, lots of walnut shavings. So, the new lathe has officially been br...

Turning A Sphere

Turning a ball is more work than you think. I first tried a simple method.. Turn a blank round Form the ball Part off and sand. Clearly, not a ball... On to step two! Chuck up a chunk of walnut, and scrape out a cup... Part off for the tailstock.... Scrape out an matched set for the chuck side.. They should match up. Insert square block.. Okay. You turn off the edges, rotate your block. Turn off more edges, rotate your block. Etc. About 15-20 minutes later... You can see how I turned a way the jam chuck as I went. The closer you get to spherical, the less you remove each rotation. Like anything practice till you're happy with it!