Skip to main content

Claro Walnut Egg

There is a challenge for the fall meeting of the local IAP turners. Eggs. The original intent was to turn only with a skew. I tried. Nothing but pain and hardship! :)

Quick template


Showing off my pretty blank


Sizing up my egg


burnishing


Last shot of attempt #1. Shortly after this I got a massive catch with the skew and lost the blank


Blank #2. Skipped the skew this time and got much further


Shellac.


Sorta pointy, and the end where I parted from the headstock wasn't perfect. Next one should be a bit more refined.
Labels:

Comments

  1. mikepeacewoodturning.blogspot.comApril 1, 2012 at 12:05 PM

    Looks good. I have turned a lot of eggs as I have found it to be a great skew skill builder while still producing something. I have dyed 'em, stained 'em, limed 'em and textured them. Great little gifts since they do not take much time and a great way to use bowl blank scraps.

    ReplyDelete

Post a Comment

Popular posts from this blog

Book Tablet Holder

Tablet stand made from a 400 page book and some epoxy resin. Paper micarta is the proper term for it, but it doesn't really capture the essence of the idea. Those 400 pages hold but a single story, and now they can upright a device capable of holding thousands of stories. And with only a book and 30 some odd ounces of epoxy, you can make your own! Just don't use a book that is one of your favorites. Which  honestly is why I picked this one, and the fact that the name was well suited! Really it's the ultimate upcycling!
Post a Comment
Read more

Rikon Mini Lathe

I got busy this weekend and completed a couple of projects. I took a number of pictures of my new lathe in action. Most of them during the turning of a recent euro stlye pen made from padauk and ebony with a CA finish. It was a SF Giants theme, and the lathe was covered with padauk streamers and ebony dust. Very cool first project. I had a little trouble with the finish owning to the extreme cold in the garage, but overall a pretty good result. As I normally do, I forgot something. I forgot to bring in the camera and upload the pictures to photobucket so I could post them. As such, there is once again no proof. sigh... Everything is simpler. No more wrench to move the tool rest or tail stock. No more indexing pin to take off the faceplate. No more hassle removing the centers or mandrels. Man what a difference! In addition I tried turning a few things between centers. Basically just mangled some spindle blanks. Good fun, lots of walnut shavings. So, the new lathe has officially been br...
Post a Comment
Read more

Turning A Sphere

Turning a ball is more work than you think. I first tried a simple method.. Turn a blank round Form the ball Part off and sand. Clearly, not a ball... On to step two! Chuck up a chunk of walnut, and scrape out a cup... Part off for the tailstock.... Scrape out an matched set for the chuck side.. They should match up. Insert square block.. Okay. You turn off the edges, rotate your block. Turn off more edges, rotate your block. Etc. About 15-20 minutes later... You can see how I turned a way the jam chuck as I went. The closer you get to spherical, the less you remove each rotation. Like anything practice till you're happy with it!
Post a Comment
Read more