Skip to main content

Sharp Idea

Just saw this for the first time today...

Rules for the Workshop:

Step 1. Check to make sure your tools are sharp.
Step 2. If you are still having trouble, go back to step 1.
Labels:

Comments

Post a Comment

Popular posts from this blog

Rikon Mini Lathe

I got busy this weekend and completed a couple of projects. I took a number of pictures of my new lathe in action. Most of them during the turning of a recent euro stlye pen made from padauk and ebony with a CA finish. It was a SF Giants theme, and the lathe was covered with padauk streamers and ebony dust. Very cool first project. I had a little trouble with the finish owning to the extreme cold in the garage, but overall a pretty good result. As I normally do, I forgot something. I forgot to bring in the camera and upload the pictures to photobucket so I could post them. As such, there is once again no proof. sigh... Everything is simpler. No more wrench to move the tool rest or tail stock. No more indexing pin to take off the faceplate. No more hassle removing the centers or mandrels. Man what a difference! In addition I tried turning a few things between centers. Basically just mangled some spindle blanks. Good fun, lots of walnut shavings. So, the new lathe has officially been br...
Post a Comment
Read more

Book Tablet Holder

Tablet stand made from a 400 page book and some epoxy resin. Paper micarta is the proper term for it, but it doesn't really capture the essence of the idea. Those 400 pages hold but a single story, and now they can upright a device capable of holding thousands of stories. And with only a book and 30 some odd ounces of epoxy, you can make your own! Just don't use a book that is one of your favorites. Which  honestly is why I picked this one, and the fact that the name was well suited! Really it's the ultimate upcycling!
Post a Comment
Read more

The Burl Bowl Beat

Cool Chunk of claro walnut burl Soaked in CA Rocks and burl More burl and a void emerge Rough hollowing Shearing scrape Sanding started Started on the bottom The blank went for a short flight... I'd like to claim it was an unstable bowl but that was not the case. It was a stupid mistake on my part. I was turning down the nib at the very end of the processed when I rubbed the tool edge and got a catch. the bowl came out the cole jaws hit the tool rest and flew straight up. I was then showered in burl bowl pieces. It was spectacular! I was so upset I could barely think straight. I only found two pieces and have no idea where the other 60% of them are. Now... I understand these things happen and I just need to chuck up another block
Post a Comment
Read more