Block O Sycamore
Cut to about 8" on band saw
Rounded out with roughing gouge. added 1/4 tenon for holding in chuck
|Then I used the division to drill out a depth hole for hollowing.|
I put a burr all around the edge for scraping the bowl shape from the inside.
Took forever and I had a hard time getting a nice final shape. The bottom was a bit blocky, but with the lenght of my goblet and overhang of my scraper it was the best I could manage.
|I stuffed a shop towel in the bowl and shaped the outside|
about 30 minutes of sanding with 100 then 180. Again given the shape, getting to the bowls bottom was problematic at best.
|Added some BLO just to see. Not bad.|
All done except a finish. I put a coat of wipe on poly. Will add 2-3 more before it comes inside.